Quick Start Guide

Introduction

This section contains the quick start guide for Rotrics Arm. You can use Rotrics Studio or the touchscreen to control the arm movement. Please follow the steps below to complete Rotrics Arm initialization, control movement along XYZ axis, and control end-effector functions.

Click the left navigation bar to jump to detailed functions guide.

💡Tips for first batch backer: Please follow the instructions below to upgrade Rotrics Arm's and touchscreen firmwares first: https://www.manual.rotrics.com/product-profile/faq

Control the Arm with Rotrics Studio

1. Install Rotrics Arm

Place the Arm on a clean and flat surface, and connect to the power

2. Connect with Rotrics Studio software

  • Download Rotrics Studio software from www.rotrics.com

  • Connect the Arm with the computer with a USB-C cable

  • Open Rotrics Studio and connect to the Arm.

3. Initialize the Arm

Switch toBasic panel, click HOME button to initialize the arm

4. Control the Arm movement

Control robot arm movement with Easy Control at the bottom of software or with control buttons on the right side, as shown in the following image:

Control the Arm with touchscreen

1. Install Rotrics Arm

Place the Arm on a clean and flat surface, and connect to the power

2. Connect with the touchscreen

Use Dual Type-C cable to connect touchscreen and the Arm

3. Initialize the Arm

For the first batch backers: click Basic -> RESET first and then click HOME to complete initialization.

For the other backers or those backers who upgraded their touchscreen's firmware:

Click Basic -> HOME to complete initialization

4. Control the Arm movement

Click X±, Y±, Z± to control the Arm movement